Leadax Original Flashing is installed and formed in a similar way to traditional lead flashing.
Use your hands to pre-form Leadax Original flashing and the Leadax Dresser or Steel Pressure Roller to mold it into place.
Temperature changes have little or no effect on the expansion or contraction of the product.
Roofing Materials
Leadax Original flashing is suitable with all types of roofing materials (EPDM, bitumen, plastics and metals), only use Leadax High-Tack Sealant for fixation (not hot air)
Leadax Original flashing can be used on all lead code 5 applications.
For flat and low-slope roofs, seal edges and seams with Leadax High-Tack Sealant.
Preparation
The ideal installation temperature is from 41°F (5 °C) and rising. Leadax Original flashing can be installed in temperatures as low as -4°F (-20°C), however forming Leadax Original flashing could be more difficult and require additional time.
Ensure surface is dry and free of grease and dust before applying Leadax Original flashing.
Installation
Installs up to 19.7ft (6m) without needing an overlap.
Overlaps must be a minimum of 3.1” (80mm) and sealed with hot air or Leadax High-Tack Sealant.
The recommended welding temperature is 800°F (425°C), depending on the ambient temperature. Use the Leadax steel pressure roller to press down the welding seam.
In areas frequently exposed to wind, Leadax Original flashing can be secured using Leadax High-Tack Sealant.
When molded or used as a facing material, it is recommended to secure with Leadax High-Tack Sealant.
Use Leadax High-Tack Sealant to seal off any edges and seams.
After application, remove the protective film from the face and reverse.
(
